ALL PRICES SHOWN ARE FOR FACTORY PICK UP
EZ Dumper 8’ Aluminum Insert
The EZ-Dumper Dump Insert is the perfect solution for landscapers, general contractors and handy homeowners. It bolts directly to most full-size pickup trucks in about two hours with few or no alterations. It dumps and lowers using a 12V Monarch Hydraulic Double-Acting Pump that is connected directly to your truck’s battery. It is also available in a 6’ model that fits most short bed trucks and has a payload capacity of 1.5 cubic yards!
Easy to Install and Operate
All you need are a few common tools. No alterations are needed for most trucks. Simply slide the EZ-Dumper into your truck bed, secure it with bolts in the holes already on your truck, and you’re ready to go. To empty a payload, just open the tailgate and push the button on your remote. The EZ-Dumper lifts to an angle of 48 degrees in under 30 seconds for a quick and clean unloading.
Insert Type: EZ001AT
Unloaded Weight: 545lb
Payload Capacity: 6000lb
Volume Capacity: 2 Cubic Yards
Dump Angle: 48 degrees
Frame Construction: 1/4" angle
Side Steel: 1/8" Aluminum
Deck Steel: 3/16" Aluminum
Tailgate: Double-Acting Removeable Spreader
Energy Source: Truck Battery
Power Unit: Double Acting Monarch Pump
Cylinder(s): Mounted Under Unit
Hydraulics: Power Up/Power Down
Remote Control: Standard
Tie-down Features: Full Length Flat Bar Rub Rails
Expansion Features: 8 Stake Pockets (outside)
Lubrication: Thread in Grease Fittings on Pivots
Installation: Four Bolt-Down Clamps
Warranty 2 Years Front to Tailgate
3895.00 Factory Pick Up Price In PA. 340.00 For Cab Protector
Ft Myers Installed Price
3895.00 For Insert
500.00 Freight From PA.
340.00 Cab Protector
Total Cost installed in Ft Myers 4935.00
Can be drop shipped to any commercial location with a fork lift call for info!